Contributor
•
1 Message
Cisco NIM-4G-LTE-NA Module configuration
Need configuration to connect to LTE using a Cisco ISR 4431 router with a NIM-4G-LTE-NA Network Interface Module (NIM)
© 2023 AT&T Intellectual Property. All rights reserved. AT&T, the AT&T logo and all other AT&T marks contained herein are trademarks of AT&T intellectual property and/or AT&T affiliated companies. All other marks are the property of their respective owners.
gpauwen
Contributor
•
1 Message
7 years ago
Hello,
did you ever get an answer ? I am also looking for a sample config for the ISR4431 with a NIM-4G-LTE-NA for AT&T service...
If you have the config, can you share it ?
Thanks in advance !
0
0
phuonger
Contributor
•
1 Message
7 years ago
Any luck on this?
I'm also attempting to configure a Cisco 4321 with the 4G-LTE-NA card.
All the documents I have found referencing setup do not work or are missing some commands.
Especially having an issue where unable to set encapsulation to SLIP
0
0
WiFivomFranMan
Contributor
•
1 Message
6 years ago
Here is what my config looks like after playing round a bit. Note, I am no expert at this.
!
controller Cellular 0/2/0
lte modem link-recovery rssi onset-threshold -110
lte modem link-recovery monitor-timer 20
lte modem link-recovery wait-timer 10
lte modem link-recovery debounce-count 6
!
interface Cellular0/2/0
ip address negotiated
dialer in-band
dialer-group 1
pulse-time 1
!
interface Cellular0/2/1
no ip address
!
!
!
ip route 8.8.8.8 255.255.255.255 Cellular0/2/0
!
!
dialer-list 1 protocol ip permit
!
!
!
Then ping 8.8.8.8 and it should come up if you do show ip int bri
0
0